Jig Saw

Front

To remove the saber saw blade from an internal cut the operator should ______________.

Back

stop the saw and lift the blade out of the cut.

Front

When starting a cut with the saber saw the operator should _______________.

Back

hold the saw blade away from the wood, turn on the saw let it come to full speed and start cutting.

Front

The cut should be made _________________.

Back

on the waste side of the mark line.

Front

When cutting with the saber saw correct cutting speed can be identified when _____________.

Back

the saw is moved at a moderate speed and the RPM's do not decrease.

Front

If a saber saw is lifted from a cut while running, what will occur? Options: The blade may break., The wood will be marred., The saw will jump as the blade hits the wood., All of these could happen

Back

All of these could happen

Front

Plunge cutting can be done with the saber saw by ________________.

Back

placing the toe of the saw on the material and slowly tilting the saw blade into the cut.

Front

What is the correct term for the component that helps prevent strain on the cord? Options: Cord Strain Reliever, Aluminum Housing, Base Tilt Adjustment, Blade, Blade Screw

Back

Cord Strain Reliever

Front

What is the correct answer from the following options: Handle, Aluminum Housing, Base Tilt Adjustment, Blade, Blade Screw?

Back

Handle

Front

What is the correct term for the component among the following options: Brush Holder, Aluminum Housing, Base Tilt Adjustment, Blade, Blade Screw?

Back

Brush Holder

Front

What is the correct term for the adjustment that affects the angle of the base? Options: Base Tilt Adjustment, Aluminum Housing, Blade, Blade Screw, Brush Holder

Back

Base Tilt Adjustment