Saw Blade Study Guide

Front

What are calipers used to measure?

Back

Internal, external, and depth measurements

Front

What should the reading be on a properly calibrated caliper when the jaws are touching?

Back

0.000

Front

Which of the following is the best tool for squaring a line across a board? Options: pivot block, Mortises, Try Square

Back

Try Square

Front

What tool would be used to lay out a 35 degree angle? Options: Stock is supported at out-feed, sliding T-bevel

Back

sliding T-bevel

Front

Which of the following is a consideration before attempting to rip on a Table Saw? Stock is supported at out-feed, Internal, external, and depth measurements, will not remove a warp from a board

Back

Stock is supported at out-feed

Front

A dado head cannot cut:

Back

Mortises

Front

Ripping narrow stock on the table saw requires: 1/16", outfeed table, a splitter or riving knife, guard, fence, and push stick

Back

a splitter or riving knife, guard, fence, and push stick

Front

The size of a table saw is determined by the:

Back

blade diameter

Front

When using dado cutters on the table saw, the table insert must be replaced with a special:

Back

throat plate

Front

The blade guard on a band saw should be adjusted ________.

Back

to within 1/4" of the stock