Brakes ASE

Front

A rotor that is machined on a car compensates for: Caliper wear, Hub Flange Runout, brake pad wear, oversized drum

Back

Hub Flange Runout

Front

Machining a rotor on the car can save: brake pad wear, labor time, Hub wear, wheel bearing play

Back

labor time

Front

A Vehicle pulls to the left While driving but pulls to the right when braking. What could be the cause?

Back

seized left front caliper

Front

The piston in a claiper is retrated by a : return spring, square cut seal, dust boot, wheel cylinder

Back

square cut seal

Front

A front wheel bearing is discolored. What could be the cause? Options: insufficient bearing grease, misajusted bearing, both of the above, none of the above

Back

both of the above

Front

when installing an axle nut during replacement of a sealed wheel bearing, The technician should:

Back

tighten the axle nut then torque it.

Front

What tool can be used to test a wheel speed sensor? A Digital multi-meter, oscilloscope, both of the above, none of the above

Back

both of the above

Front

What could cause the ABS warning lamp to illuminate on the dash? Options: a faulty vehicle speed sensor, a faulty brake switch, a faulty wheel speed sensor, a failed brake booster

Back

a faulty wheel speed sensor

Front

A vehicle has a low brake pedal and inefficient braking. What could be the cause?

Back

a faulty master cylinder

Front

the best place to located the handling of hazardous chemicals is the:

Back

MSDS sheet