1st Engineering Design 1 MidTerm Study Guide

Front

Referencing the graphic, what is the AutoCAD command shown?

Back

fillet

Front

Which symbol can be used to specify angle for making an inclined plane? Options: <, >, @, #

Back

<

Front

To make the arc as shown in the graphic, which arc command can be most effective? Options: Three point arc, Start End Radius, Center Start End, Center Start Length

Back

Center Start End

Front

The extension for an AutoCAD drawing files is

Back

DWG

Front

What should be the angle of the horizontal line so as to rotate it to the position of the green line?

Back

-30 degrees

Front

In the image shown, what is the offset distance between both the closed geometries?

Back

1

Front

To reduce the size of an object to half of its initial value using the SCALE command, the scale factor would be?

Back

0.5

Front

In the rectangular array shown, what is the gap between rows?

Back

1.5

Front

What will you use in the command line to make a line with a length of 8 units at an angle of 60 degrees (with respect to the positive direction of X axis), assuming you use the line command and the base point of the line is not at the origin? Options: 60<8, 5<60, @60<8, @8<60

Back

@8<60

Front

Which option of the status bar will activate the Tooltip as shown on the cursor? ortho mode, polar tracking, object snap, dynamic input

Back

dynamic input