Dremel Safety Flashcard

Front

Use __________ or another practical way to secure and support the work piece to a stable platform.

Back

Clamps/Vice

Front

Accessories must be rated for at least the ___________ recommended on the tool warning label.

Back

Speed

Front

If cutting into existing walls or other blind areas where electrical wiring may exist is unavoidable, _______________all fuses or circuit breakers feeding this worksite.

Back

disconnect

Front

Do not operate the ___________ shaft with a sharp bend.

Back

flexible

Front

Be aware of the __________location, when placing the tool down or when picking the tool up.

Back

switch

Front

Always hold the hand piece _______ in your hands during the start-up.

Back

firmly

Front

Always wear ____________and dust mask. Use only in well ventilated area.

Back

safety goggles

Front

After changing the bits or making any adjustments, make sure the collet nut and the EZ TWIST integrated wrench/ nose cap are both securely ______________.

Back

tightened

Front

Do not reach in the area of the__________bit.

Back

spinning

Front

Allow brushes to run at__________speed for at least one minute before using wheel. During this time no one is to stand in front or in line with the brush.

Back

operating