Drum Brakes

Front

A line wrench or ___________ wrench is a recommended tool for removing brake lines from a wheel cylinder.

Back

Flare nut

Front

If one rear brake assembly has linings contaminated with grease from a failed axle seal, __________.

Back

The lining on both wheel brake units will need to be replaced

Front

Who is correct regarding the use of a brake spoon and a brake hold-down spring tool? Tech A says that a brake spoon is used to adjust brake shoes when the drum is installed. Tech B says that a brake hold-down spring tool is used to remove and install hold-down springs.

Back

Both Techs A and B

Front

A technician notices brake fluid dripping from a brake drum before repairs. Which is most likely leaking inside the drum?

Back

wheel cylinder

Front

The primary (smaller) shoe on a duo-servo drum brake system should be installed:

Back

toward the front of the car.

Front

While performing rear drum brake service, what should be done before installing the brake drum? A. adjusting the shoes, B. bleeding the brakes, C. installing a C-clamp, D. installing the lugnuts

Back

adjusting the shoes

Front

A technician finds brake fluid leaking from a wheel cylinder and finds the brake shoes have been saturated with brake fluid. The correct way to repair this is to install a new wheel cylinder and:

Back

replace the shoes.

Front

When replacing brake shoes, where does the shoe with the shortest friction material go?

Back

facing toward the front of the vehicle

Front

When removing a hubless brake drum, it may be necessary to use a(n) _______ hammer to hammer on the drum between the lug studs.

Back

Ball peen

Front

You can usually tell which style of brake drum you are working on by looking at the ________.

Back

Holes for the lug studs