
ASE A4 Steering and Suspension Practice Exam
Flashcard
•
Other
•
10th Grade - University
•
Practice Problem
•
Easy
Wayground Content
Used 1+ times
FREE Resource
Student preview

40 questions
Show all answers
1.
FLASHCARD QUESTION
Front
A vehicle has a steady pull to the left. All of these will cause this condition EXCEPT: The caster angle., Low tire pressure., The camber angle., Steering U-joint coupling.
Back
Steering U-joint coupling.
2.
FLASHCARD QUESTION
Front
Who is correct regarding camber effects on vehicle alignment? Technician A says a vehicle will pull to the side with the most positive camber. Technician B says that too much negative camber will result in excessive wear on the inside tread of the tire.
Back
Both Technician A and B
3.
FLASHCARD QUESTION
Front
Two technicians are discussing inner and outer tie rods. Technician A says to turn the outer tie rod end to adjust the toe. Technician B says loose inner tie rod ends will cause a tire to feather. Who is correct?
Back
Technician B only
4.
FLASHCARD QUESTION
Front
The rear tires on a vehicle with independent rear suspension are worn on the inside tread. Which of the following is MOST likely the cause of this condition? Options: The toe., Underinflated tires., The caster., None of the above.
Back
The toe.
5.
FLASHCARD QUESTION
Front
Technician A says SAI or Steering Angle Inclination is adjusted by changing the caster angle. Technician B says camber adjustments are included in the Included Angle. Who is correct?
Back
Technician B only
6.
FLASHCARD QUESTION
Front
On cold mornings, the warning lamp on a vehicle with a TPMS tire pressure monitoring system stays illuminated for several minutes before it goes out. Which of these is MOST likely the cause of this condition?
Back
Low tire pressure.
7.
FLASHCARD QUESTION
Front
A front wheel drive vehicle is pulling to the left. Loose engine cradle bolts are noticed during the initial inspection. Technician A says loose engine cradle bolts will cause a vibration, but have no affect on the vehicle's steering system. Technician B says if the engine cradle is not centered before fastening the bolts, the wheel alignment angles will be affected. Who is correct?
Back
Technician B only
Access all questions and much more by creating a free account
Create resources
Host any resource
Get auto-graded reports

Continue with Google

Continue with Email

Continue with Classlink

Continue with Clever
or continue with

Microsoft
%20(1).png)
Apple
Others
Already have an account?