08.04.01 Fits and tolerancing

05.05 Fits and

Multiple Choice

The diameter of a hole is 1.00 ± 0.03. Which of these diameters would be used when finding the maximum material condition?

• 0.97

• 1.00

• 1.03

• 0.06

Multiple Choice

The overall height of an object is 1.750 ± 0.005. Which of these heights would be used when finding the MMC (maximum material condition)?

• 1.745

• 1.750

• 1.755

• 0.010

Multiple Choice

The diameter of a hole is 0.50 ± 0.02. The pin that is inserted into the hole has diameter 0.53 ± 0.02. What is the allowance?

• 0.01

• 0.02

• 0.03

• 0.07

Multiple Choice

The diameter of a hole is 0.50 ± 0.02. The pin that is inserted into the hole has diameter 0.53 ± 0.02. Which term best describes this fit?

• Clearance

• Interference

• Transition

• Variance

Multiple Choice

The diameter of a hole is dimensioned as 0.750 ± 0.003. Which of the following could be the diameter of a peg that has clearance fit with the hole?

• 0.750 ± 0.003

• 0.750 ± 0.001

• 0.730 ± 0.010

• 0.700 ± 0.050

Multiple Choice

When a hole is always smaller than the part being placed inside of it, what type of fit is this?

• Clearance

• Interference

• Transition

• Tension

Multiple Choice

Which type of tolerance is used for the overall height of this part?

• Limit dimensions

• Bilateral tolerance

• Unilateral tolerance

• Religious tolerance

Multiple Choice

The diameter of a rod is 1.00 ± 0.03. Which of these diameters would be used when finding the LMC (least material condition)?

• 1.00

• 1.03

• .97

• .907

Multiple Choice

This type of fit is created when a greater shaft/rod diameter is pressed/forced into a smaller hole diameter. 

• Interference Fit
• Clearance Fit
• Transition Fit
• Tolerance Fit

Multiple Choice

This type of fit is created when there is space between shaft/rod diameter is diameter of the hole. 

• Interference Fit
• Clearance Fit
• Transition Fit
• Tolerance Fit

Multiple Choice

This type of fit is created when there is sometimes interference or sometimes a clearance between shaft/rod diameter is diameter of the hole. 

• Interference Fit
• Clearance Fit
• Transition Fit
• Tolerance Fit