Q3 WEEK 2 DAY 2-3 CSS

Q3 WEEK 1 DAY 2-3 CSS

By Jonalyn Rosario

Safety Precautions While Working on Computers

Safe working conditions help prevent injury to people and damage to computer equipment. You will be able to reduce the chance of accidents (such as cuts, burns, electrical shock, damage to eyesight and others) that may occur while working on computers by following these basic safety precautions:

Some text here about the topic of discussion

• Regularly inspect your tools to make sure that they are in good condition.

• Remove your watch and jewelry and secure loose clothing.

• Turn off the power and unplug equipment before performing a service.

• Cover sharp edges inside the computer case with tape.

• Never open a power supply or a CRT monitor.

• Only operate tools according to manufacturers' instructions

• After using a tool, clean it and return it to its proper storage place.

basic safety precautions:​

Some text here about the topic of discussion

• The use of hand tools starts with tools that work well. Hand tools are useful in our everyday lives, but they can also cause harm if not checked and used correctly. As a beginner, it is a must that you know how to use tools that are the right size and right type for your joband always follow the correct procedure for using every tool.

Appropriate Hand Tools for Proper Operation and Safety

Some text here about the topic of discussion

Proper Use of ESD Tools

Some text here about the topic of discussion

Proper Use of Cleaning Materials

Some text here about the topic of discussion

Identify Unsafe or Faulty Tools for Repair

Some text here about the topic of discussion

​These are the different ways to determine the faulty or defective and non-defective hand tools:

Identify Unsafe or Faulty Tools for Repair

Some text here about the topic of discussion

​These are the different ways to determine the faulty or defective and non-defective hand tools:

• Deformations • Visual Damage • Pre-production anomalies • Loose components

Any item with these defects should be coded as Defective with the specification of its defective state.

Mark Unsafe or Faulty Tools