Cisco 10.13

Multiple Choice

What is the correct way packets travel in a network?

• In a straight line from sender to receiver

• Hop-by-hop through several devices

• Directly from sender to receiver without stops

• Through a single device only

Multiple Choice

What clarification is provided regarding packet routing in networks?

• Packets always take the same route

• Packets can change routes based on conditions

• Packets never arrive at their destination

• Packets are always disabled

Multiple Choice

Loke used a tool to track the route taken by an IP packet from their school computer to the IP address of the KhanAcademy.org server.

The results are in the table.

If Loke runs the tool again, what output would he expect to see?

• He might see the same stops or might see a different sequence of stops.

• He would see the same stops, but a different amount of time at each stop.

• He will definitely see a different sequence of stops.

• He would see the same stops and the same amount of time at each stop.

Multiple Choice

How can managed switches be configured?

• Through physical buttons on the device

• Via a command-line interface or a web-based management GUI

• Only through a web-based management GUI

• They cannot be configured

Multiple Choice

What must be done before adding an expansion module in Packet Tracer?

• Power on the device

• Power off the device

• Install the module in any slot

• Remove existing modules

Multiple Choice

What type of cable is used for connecting a PC to a switch?

• Copper Straight-Through

• Copper Cross-Over

• Fiber

• Serial

Multiple Choice

What must you do before adding a module to a router in Packet Tracer?

• Turn the device on

• Turn the device off

• Choose the correct cable type

• Select the right port

Multiple Choice

What command should be used in the CLI to check if ports are up or down?

• show ip interface brief

• check port status

• interface status

• show port status