Dovetail and Mortise and Tenon Joints

A rectangular hole cut in wood is known as a:

• Tenon
• Mortise
• dovetail
• none of these

The projecting piece of wood shaped to fit into the hole in a mortise-and-tenon joint is the _____.

• Tenon
• Blind
• Width
• Length

The ____ of a mortise depends on whether the mortise is a blind or through mortise.

• Tenon
• Length
• Depth
• Through

The two pieces that are joined in a dovetail joint are the ___ piece and the tail piece.

• Rabbet
• Blocks
• Blind
• Socket

You can make a dovetail joint using a dovetail jig and a router with a(n) ____ bit.

• Tenon
• Dovetail
• Router

The back of a case is usually fitted using a(n) ____ joint.

• Rabbet
• Standard
• Fixed

____ is a box turned on it's end or edge.

• Case
• Casework
• Box
• Enclosure

When a(n) ____ mortise is used, the end of the tenon cannot be seen when the parts are assembled.

• Blind
• Tenon
• Open
• Round

The _______ of a mortise is the same as the thickness of the tenon.

• Depth
• width
• lengthlength
  
• height

The horizontal parts that join the legs of a table or stool are called ________.

• Sides
• braces
• rails
• lips