Chapter 11

A safety stand is also called a _________________.

• Jack         
• Jack Stand             
• Bottle jack
• Safety Stool

A creeper should be stored _______________.

• Vertically
• Under a vehicle
• Flat on the floor
• Upside down

Commonly damaged areas of a vehicle during hoisting include ___________.

• Rocker panels
• Exhaust systems
• Tires or body parts
• All the theses

Technician A says that a hoist can be stopped at any level as long as the safety latches engages. Technician B says that the vehicle should be hoisted to the top of the travel and set on the locks for safety. Which Technician is correct?

• Technician A only
• Technician B only
• Both Technicians
• Neither Technician A nor B

Before lowering the vehicle, what should the technician do?

• Be sure nothing is underneath the vehicle
• Raise the vehicle enough to release the safety latch
• A.  Be sure no one will be under or near the vehicle
• All the theses

The SAE standard for hoist location is ________________.

• J-1980
• JRP-2184
• SAE-2009
• J-14302

Tall safety stands would be used to ___________________.

• Help support the vehicle when a major component is removed from the vehicle 
• Lift a vehicle
• Lift a component such as a engine high off the ground from the vehicle
  
• Both  2 and 3

Pad extensions may be needed when hoisting what type of vehicle?

• Small cars
• Pickup trucks
• Vans
• Pickup trucks & Vans

Technician A says that a creeper should be stored vertically. Technician B says that a creeper should be stored on it casters. Which technician is correct?

• Technician A only
• Technician B only
• Both Technicians
• Neither Technician A nor B

When checking for stability, how high should the vehicle be raised?

• About 2 In.
• About 2 ft.
• About 1 ft.
• About 3 ft.