ACRT 153 Mid-Term Prep 2018 2

Technician A says that when removing a seized hexagon nut, heat should be applied to the bolt.

Technician B says that hardware that has been heated foe removal must be replaced with new hardware.

Who is right?

• A only.

• B only.

• Both A and B.

• Neither A nor B.

To remove rivets that hold glasses to the regulator, which of these tools is used?

• Air hammer

• Cold chisel

• Drill

• Bolt cutter

Technician A says that tempered glass breaks by shattering into small pellets that have no sharp edges.

Technician B says that laminated safety glass breaks by shattering into large pieces that fall from the opening.

Who is right?

• A only.

• B only.

• Both A and B.

• Neither A nor B.

Left hand threads are usually found on rotating parts?

• True

• False

When replacing a hinged hatch glass the hydraulic lifting struts should be:

• disconnected with the glass in the fully opened position.

• held in the compressed state by a pair of plyiers.

• disconnected with the glass fully closed and latched.

• checked for bent ends and straightened if needed.

Horizontally mounted hood hinges allow the hood to be adjusted forward and rearward.

• True

• False

When removing inner and outer door handles,the door glass should be:

• fully raised.

• fully lowered.

• partialy opened.

• removed.

Technician A says when using a wetting solution, decals can be lifted and re positioned while they are wet.

Technician B says that a 3mm (1/8") razor blade cut should be made in decals to remove air bubbles.

Who is right?

• A only.

• B only.

• Both A and B.

• Neither A nor B.

A tailgate may have a latch on both sides.

• True

• False

All of these may be parts of hinged vent window assembly EXCEPT a:

• latch

• weatherstrip

• hydraulic strut

• hinge