Before leaving the belt/disc sander work area _____.

• turn off the sander

• clean the work area

• all of these

• wait for all moving parts to stop

Ensure that hands and fingers never come closer than _____ inches from the belt or disc.

• 4

• 3

• 2

• 1

How many people can operate the stationary belt/disc sander at the same time?

• 1

• 2

• 3

• 4

If the belt or disc slows down when you apply pressure, it is likely _____.

• you are apply too much pressure

• you need to adjust the belt tension

• the sandpaper needs to be replaced

• the motor needs to be replaced

If you reach over the disc to use the belt,

• sawdust will be thrown toward the operator.

• you will achieve proper sanding of your project.

• it could cause an injury or get your clothes caught in the machine.

• you are operating the belt/disc sander properly.

Only sand stock that is _____.

• too small to hold by hand

• hardwoods

• large enough to hold by hand

• softwoods

PPE for the belt/disc sander includes: _____.

• safety glasses

• safety glasses, dust mask, hearing protection, and gloves

• safety glasses and dust mask

• safety glasses, dust mask, and hearing protection

The belt tracking must be _____ to insure the belt is not touching any metal on the sander.

• tightened

• checked by the instructor

• checked often

• loosened

When changing sand paper for the disc or belt, you need to _____.

• turn off the sander

• clean the work area first

• disconnect the power supply

• remove all safety guards and shields

When sanding stock with the disc, be sure to sand material _____.

• from the center to the right

• on the center of the disc

• from the center of the disc to the side that is rotating down

• from the center to the left