MPR-UNIT-01

MPR-UNIT-01

University

43 Qs

quiz-placeholder

Similar activities

STIs

STIs

KG - University

40 Qs

World War I TEST

World War I TEST

7th Grade - University

41 Qs

Python Set

Python Set

University

40 Qs

GENERAL SCIENCE PART 4 APRIL 25, 2021

GENERAL SCIENCE PART 4 APRIL 25, 2021

University

45 Qs

Chapter 1 Introduction to Ergonomics

Chapter 1 Introduction to Ergonomics

University

44 Qs

ecotourism  finals

ecotourism finals

University

41 Qs

A&P Chapter 7

A&P Chapter 7

University

40 Qs

Piano Basics

Piano Basics

KG - University

45 Qs

MPR-UNIT-01

MPR-UNIT-01

Assessment

Quiz

Other

University

Hard

Created by

Rajesh Kale

Used 4+ times

FREE Resource

43 questions

Show all answers

1.

MULTIPLE CHOICE QUESTION

30 sec • Ungraded

Which machine tool is known as the mother machine tool?

a) drill

b) milling

c) lathe

d) none of mentioned

a) drill

b) milling

c) lathe

d) none of mentioned

c

2.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Lathe is primarily used for producing ____surfaces.

a) flat

b) curve

c) taper

d) none of the mentioned

d

3.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

What is the necessary condition for turning?

a) material of work piece should be harder than the cutting tool

b) cutting tool should be harder than the material of work piece

c) hardness of the cutting tool and material of of piece should be same

d) none of the mentioned

b

4.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Traversing of tool parallel to the axis of job is termed as_____

a) cross feed

b) longitudinal feed

c) both cross feed and traversing feed

d) none of the mentioned

b

5.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

In taper operation, which type of surface is produced?

a) flat

b) curve

c) circular

d) none of the mentioned

d

6.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Which type of lathe is also known as centre lathe?

a) engine lathe

b) bench lathe

c) room lathe

d) capstan lathe

a

7.

MULTIPLE CHOICE QUESTION

30 sec • 1 pt

Which of the following is the base of the lathe machine?

a) bed

b) tailstock

c) headstock

d) none of the mentioned

Create a free account and access millions of resources

Create resources
Host any resource
Get auto-graded reports
or continue with
Microsoft
Apple
Others
By signing up, you agree to our Terms of Service & Privacy Policy
Already have an account?