CTE Router Test

The part used to hold in the bits in a portable router is the ________

• Collet

• Jacobs Chuck

• 4 Jaw Chuck

• Pilot

When starting a cut with the router, the bit should be______

• Not be in contact with the stock

• Be in place and ready to start cutting immediately

• Slightly tilted to make starting easier

• Elevated to make it easier to see

Feeding the router to fast will result in ________

• Fine cuts

• Excessive wear

• Burning the wood

• Splintering

Which is not a safety precaution for the router?

• Wear safety glasses

• Hold the router with both hands

• Use a bit with a pilot end

• Disconnect power before changing the bits

When changing cutters, one should insert the shank of the bit ______ inch into the chuck

• 1/8

• 1/4

• 3/4

• 1/2

Cutting with the router is more efficient if the router is moved _______

• Clockwise

• Counter clockwise

• Left to right

• Right to left

Which of the following should be observed when using a router ________

• Do not stand in wet or damp places

• Wear a dust mask

• Wear safety glasses

• All are correct

The depth of the cut on the router is made by turning the ______

• Collet Adjustment

• Micro Meter Depth Adjustment

• Guild Adjustment

• Frame Adjustment

After the cut is complete, one should ________

• Lift the router from their work

• Disconnect the router

• Shut off the motor

• Wait till the bit stops rotating before you continue with anything else

To prevent splintering at the corners, one should cut the _____________ first

• End grain

• Middle section

• Left side

• Right side