Power Tools

Before replacing parts such as bits, blades, or discs on any tool, you must _____.

• a. polish it with a fine steel wool
• b. recharge the tool's battery
• c. disconnect the power source
• d. inspect them for cracks

Before you plug any saw into a power source, make sure the _____.

• a. speed is set to Low
• b. power switch is in the Off position
• c. work has been clamped down
• d. lower blade guard is pulled back

Special training and certification is required before using any kind of _____.

• a. powder-actuated fastening tool
• b. electrically powered tool
• c. pneumatic nail or screw system
• d. hydraulic lift or press tool

If a pneumatic nailer is not firing properly, before attempting repairs be sure to _____.

• a. adjust the compressor
• b. disconnect the air hose
• c. adjust the regulator
• d. remove the booster

The jigsaw is particularly suited to cutting _______.

• metal

• curved lines

• straight lines

• miters

Power-driven fastening tools include finish nailers, brad nailers, and _______.

• staplers

• hammers

• jigsaws

• laminate trimmers

The _________ saw is predominately used for demolition.

• circular

• jig

• router

• reciprocating

How is the size of a portable circular saw determined?

• motor

• amps

• largest blade it will hold

• it is labeled on the tool

Name this power tool

• bench saw

• table saw

• flat saw

• miter saw

Name this power tool

• miter saw

• circular saw

• skill saw

• table saw