When is fall protection required in the construction industry? Select all that apply.

• When working at a height of four feet

• When working over dangerous machinery or equipment

• Only when working on scaffolds

• When working at a height of six feet or more

An ironworker is standing 30 feet in the air on a tilt-up concrete wall, throwing out bridging. He is wearing a harness and lanyard but is not tied-off. Is this a fall hazard?

• Yes

• No

To access a landing that is nine feet above the adjacent floor, a worker climbs an unsecured 10-foot ladder that has slip-resistant feet. Does this ladder pose a fall hazard to the worker?

• Yes

• No

Which of the following answer options are ways to prevent falls from ladders? Select all that apply.

• Choose the right ladder for the job.

• Use the ladder your coworker uses.

• Don't carry tools or materials in your hands while climbing.

• Tie off the top and bottom to fixed points.

Which of the following is a fall prevention system?

• Personal fall arrest system

• Safety net system

• Guardrail

• Top rail

How close should safety nets be to the working surface?

• As close as possible below the working surface

• At least 10 feet below the working surface

• Safety nets should never be near working surfaces.

What provides a secure point of attachment for lifelines, lanyards, or deceleration devices?

• Full-body harness

• Connector

• Anchor and anchor connector

Which of the following actions does OSHA require employers to take when providing construction workers with fall protection? Select all that apply.

• Ensure that fall protection equipment is appropriate to the task.

• Call attention to unique fall hazards.

• Eliminate general fall prevention training.

Do you feel confident in recognizing fall hazards ?

• Yes, I feel confident to recognize fall hazards

• No, I do not feel confident in recognizing fall hazards

• Yes, I feel confident but I need more training

• No way, falling is scary

• What is a fall hazard ?