Steering 6

What is equipment pictured?

• Dunlop Tracking Gauge

• Laser wheel aligner

• Analog tracking gauge

• Camber gauge

What type of loads are exerted on wheel bearings

• Axial and Radial

• Axle and Radial

• Axial and Radii

• Axle and Radius

Because of there long fine needle rollers, these bearings can support heavy loads?

• True

• False

Taper roller bearings are used in pairs mounted:

• Tapers opposing, larger bearing inside.

• Tapers opposing , larger bearing outside

• Tapers Facing out, larger bearing inside.

• Tapers facing in, larger bearing outside.

Why are plain bearings most common?

• Very low friction

• Very high friction

• Only require one race

• Do not require any lubrication

Where the axle is supported on it's inner end by a roller bearing, and a taper bearing inside the housing. This is known as a:

• Semi-floating axle shaft

• Half axle

• Three quarter axle

• Non-driven axle

Where two taper roller bearings are used between each hub and axle. This is known as?

• Full floating axle shaft

• Semi-floating axle

• Semi-trailing axle

• Full trailing axle

What bearing type is shown in picture?

• Taper roller

• Roller

• Needle

• Ball bearing

What type of hub si pictured?

• Non-driven

• Driven

• Semi- floating

• Half floating

What type of hub is pictured?

• Driven

• Non-driven

• Fully dependent

• Rear stub axle