Quarter 1 Test

Stock shorter than_____inches should not be run on the jointer.

• 14

• 12

• 10

• 18

Place the convex or concave edge or face against the fence table.

• concave

• convex

• Bent

• Straight

Stock shorter than_____inches should not be run on the jointer.

• 14

• 12

• 10

• 18

The depth of cut is adjusted by moving the_____table up or down this is also the table you start feeding your stock into.

• Back

• Outfeed

• Front

• Infeed

the fence tilting handwheel is used to adjust____angles.

• Little

• relief

• Bevel

• Tilting

Maximum depth of cut for edge jointing____inches and face jointing____inches.

• 1/4

• 1/8

• 1/3

• 1/16

A________should be used for short stock and in finishing the end of long stock as it passes over cutter head

• your hand

• Push stick

• Your teacher

• Piece of wood

The____table should only be adjusted be a qualified person

• Outfeed

• infeed

• Outfield

• Infield

When finished jointing your stock it is your responsibility to make sure the____is stopped before leaving the machine.

• outfeed

• fence

• infeed

• Cutterhead

The stock should be feed into the jointer so the machine is cutting____the grain and not____ the grain or____grain

• against/forward/front

• with/across/end

• end/with/across

• all of the above