
ASE A5 BRAKES PRACTICE TEST
Authored by Francisco Montes
Other
9th - 12th Grade
Used 6+ times

AI Actions
Add similar questions
Adjust reading levels
Convert to real-world scenario
Translate activity
More...
Content View
Student View
60 questions
Show all answers
1.
MULTIPLE CHOICE QUESTION
1 min • 1 pt
There is pulsation in the steering wheel only when brakes are applied. Which of the following is causing this condition?
an out of round tire .
Front rotor lateral runout
A cupped tire.
warped rear rotors.
2.
MULTIPLE CHOICE QUESTION
1 min • 1 pt
which of the following input sensors are used by the traction and stability control systems?
Yaw rate sensor.
Steering angle sensor.
Wheel speed sensor.
All of the above.
3.
MULTIPLE CHOICE QUESTION
1 min • 1 pt
A technician is lubricating rubber brake components while performing a brake job. Technician A says to use a high temperature silicon-based lubricant. Technician B says to use a petroleum-based lubricant. Who is correct?
Tech A
Tech B
Both A and B
Neither A or B
4.
MULTIPLE CHOICE QUESTION
1 min • 1 pt
A technician is testing a vehicle with a vacuum assist brake booster. after pumping the brake pedal several times and starting the engine, the pedal drops toward the floor 1/4 of an inch . which of the following statement is correct?
This is normal.
The brake booster is faulty.
The master cylinder is faulty.
There is air in the brake system.
5.
MULTIPLE CHOICE QUESTION
1 min • 1 pt
The front brake pads on a vehicle with a quick take-up master cylinder need replacement. They were recently replaced. Tech A says this is a low drag brake system. Tech B says the master cylinder quick take-up valve could be sticking.
Who is correct?
Tech A
Tech B
Both A and B
Neither A or B
6.
MULTIPLE CHOICE QUESTION
1 min • 1 pt
After replacing all four rotors and pads on a disk brake system a pulsation is still being felt in the steering wheel when braking. Which of the following is MOST likely causing this vibration?
A rusty Hub flange
sticking slide pins
thickness vibration
Lateral runout
7.
MULTIPLE CHOICE QUESTION
1 min • 1 pt
A vehicle has soft and spongy brake pedal at all times. which of the following is causing this spongy pedal?
Air in brake lines.
low manifold vacuum
The brake booster
master cylinder cup seals.
Access all questions and much more by creating a free account
Create resources
Host any resource
Get auto-graded reports

Continue with Google

Continue with Email

Continue with Classlink

Continue with Clever
or continue with

Microsoft
%20(1).png)
Apple
Others
Already have an account?