9. Which set of action satisfy the requirement for multifactor authentication?

B. The user enters a user name and password, and then clicks a notification in an authentication app on a mobile device.

A. The user swipes a key fob, then clicks through an email link.

C. The user enters a PIN into an RSA token, and then enters the displayed RSA key on a login screen.

D. The user enters a user name and password and then re-enters the credentials on a second screen.

10. Which two capacities of Cisco DNA Center make it more extensible? (Choose two)

B. SDKs that support interaction with third-party network equipment

D. REST APIs that allow for external applications to interact natively with Cisco DNA Center

A. adapters that support all families of Cisco IOS software

C. customized versions for small, medium, and large enterprises

E. modular design that is upgradable as needed

13. Which two must be met before SSH can operate normally on a Cisco IOS switch? (Choose two)

A. The switch must be running a k9 (crypto) IOS image.

B. The ip domain-name command must be configured on the switch.

C. IP routing must be enabled on the switch.

D. A console password must be configured on the switch.

E. Telnet must be disabled on the switch.

16. How does HSRP provide first hop redundancy?

D. It uses a shared virtual MAC and a virtual IP address to a group of routers that serve as the default gateway for hosts on a LAN.

A. It load-balances traffic by assigning the same metric value to more than one route to the same destination m the IP routing table.

B. It load-balances Layer 2 traffic along the path by flooding traffic out all interfaces configured with the same VLAN.

C. It forwards multiple packets to the same destination over different routed links n the data path.

17. In Which way does a spine-and-leaf architecture allow for scalability in a network when additional access ports are required?

D. A leaf switch can be added with connections to every spine switch.

A. A spine switch and a leaf switch can be added with redundant connections between them.

B. A spine switch can be added with at least 40 GB uplinks.

C. A leaf switch can be added with a single connection to a core spine switch.

18. Which two actions are performed by the Weighted Random Early Detection mechanism? (Choose two)

A. It drops lower-priority packets before it drops higher-priority packets.

D. It can mitigate congestion by preventing the queue from filling up.

B. It can identify different flows with a high level of granularity.

C. It guarantees the delivery of high-priority packets.

E. It supports protocol discovery.

20. Refer to the exhibit. What is the effect of this configuration?

A. The switch port interface trust state becomes untrusted.

B. The switch port remains administratively down until the interface is connected to another switch.

C. Dynamic ARP inspection is disabled because the ARP ACL is missing.

D. The switch port remains down until it is configured to trust or untrust incoming packets.

22. How do TCP and UDP differ in the way that they establish a connection between two endpoints?

D. TCP uses the three-way handshake and UDP does not guarantee message delivery.

A. TCP uses synchronization packets, and UDP uses acknowledgment packets.

B. UDP uses SYN, SYN ACK and FIN bits in the frame header while TCP uses SYN, SYN ACK and ACK bits.

C. UDP provides reliable message transfer and TCP is a connectionless protocol.

23. When OSPF learns multiple paths to a network, how does it select a route?

C. It divides a reference bandwidth of 100 Mbps by the actual bandwidth of the existing interface to calculate the router with the lowest cost.

A. It multiple the active K value by 256 to calculate the route with the lowest metric.

B. For each existing interface, it adds the metric from the source router to the destination to calculate the route with the lowest bandwidth.

D. It count the number of hops between the source router and the destination to determine the router with the lowest metric.

25. Which configuration is needed to generate an RSA key for SSH on a router?

A. Configure the version of SSH.

C. Create a user with a password.

27. What is the primary different between AAA authentication and authorization?

C. Authentication identifies and verifies a user who is attempting to access a system, and authorization controls the tasks the user can perform.

A. Authentication verifies a username and password, and authorization handles the communication between the authentication agent and the user database.

B. Authentication identifies a user who is attempting to access a system, and authorization validates the users password.

D. Authentication controls the system processes a user can access and authorization logs the activities the user initiates.

28. A Cisco IP phone receive untagged data traffic from an attached PC. Which action is taken by the phone?

A. It allows the traffic to pass through unchanged.

C. It tags the traffic with the default VLAN.

D. It tags the traffic with the native VLAN.

29. An engineer must configure a/30 subnet between two routers. Which usable IP address and subnet mask combination meets this criteria?

D. interface e0/0 description to HQ-A370:98968 ip address 209.165.201.2 255.255.255.252

A. interface e0/0 description to HQ-A370:98968 ip address 10.2.1.3 255.255.255.252

B. interface e0/0 description to HQ-A370:98968 ip address 192.168.1.1 255.255.255.248

C. interface e0/0 description to HQ-A370:98968 ip address 172.16.1.4 255.255.255.248

30. What is a benefit of using a Cisco Wireless LAN Controller?

D. It eliminates the need to configure each access point individually.

A. Central AP management requires more complex configurations.

B. Unique SSIDs cannot use the same authentication method.

C. It supports autonomous and lightweight APs.

31. What are two characteristics of a controller-based network? (Choose two)

B. It uses northbound and southbound APIs to communicate between architectural layers.

C. It moves the control plane to a central point.

A. The administrator can make configuration updates from the CLI.

D. It decentralizes the control plane, which allows each device to make its own forwarding decisions.

E. It uses Telnet to report system issues.

33. Refer to Exhibit. How does SW2 interact with other switches in this VTP domain?

C. It forwards only the VTP advertisements that it receives on its trunk ports.

A. It processes VTP updates from any VTP clients on the network on its access ports.

B. It receives updates from all VTP servers and forwards all locally configured VLANs out all trunk ports.

D. It transmits and processes VTP updates from any VTP Clients on the network on its trunk ports.

36. What are two reasons that cause late collisions to increment on an Ethernet interface? (Choose two)

B. when the cable length limits are exceeded

C. when one side of the connection is configured for half-duplex

A. when the sending device waits 15 seconds before sending the frame again

D. when Carriner Sense Multiple Access/Collision Detection is used

38. What is the primary effect of the spanning-tree portfast command?

B. It minimizes spanning-tree convergence time

C. It immediately puts the port into the forwarding state when the switch is reloaded

D. It immediately enables the port in the listening state

39. What is the default behavior of a Layer 2 switch when a frame with an unknown destination MAC address is received?

B. The Layer 2 switch floods packets to all ports except the receiving port in the given VLAN.

A. The Layer 2 switch drops the received frame.

C. The Layer 2 switch sends a copy of a packet to CPU for destination MAC address learning.

D. The Layer 2 switch forwards the packet and adds the destination MAC address to its MAC address table.

40. Refer to the exhibit. What is the effect of this configuration?

D. The switch discard all ingress ARP traffic with invalid MAC-to-IP address bindings.

A. All ARP packets are dropped by the switch.

B. Egress traffic is passed only if the destination is a DHCP server.

C. All ingress and egress traffic is dropped because the interface is untrusted.

44. Which two values or settings must be entered when configuring a new WLAN in the Cisco Wireless LAN Controller GUI? (Choose two)

A. management interface settings

C. Ip address of one or more access points

45. Which two actions influence the EIGRP route selection process? (Choose two)

B. The router calculates the best backup path to the destination route and assigns it as the feasible successor.

C. The router calculates the feasible distance of all paths to the destination route.

A. The router calculates the reported distance by multiplying the delay on the exiting Interface by 256.

D. The advertised distance is calculated by a downstream neighbor to inform the local router of the bandwidth on the link.

E. The router must use the advertised distance as the metric for any given route.

46. Refer to Exhibit. Which action do the switches take on the trunk link?

B. The trunk forms but the mismatched native VLANs are merged into a single broadcast domain.

A. The trunk does not form and the ports go into an err-disabled status.

C. The trunk does not form, but VLAN 99 and VLAN 999 are allowed to traverse the link.

D. The trunk forms but VLAN 99 and VLAN 999 are in a shutdown state.

49. An office has 8 floors with approximately 30-40 users per floor What command must be configured on the router Switched Virtual Interface to use address space efficiently?

B. ip address 192.168.0.0 255.255.254.0

A. ip address 192.168.0.0 255.255.0.0

C. ip address 192.168.0.0 255.255.255.128

D. ip address 192.168.0.0 255.255.255.224

51. What criteria is used first during the root port selection process?

B. lowest path cost to the root bridge

C. lowest neighbor’s bridge ID

Test CCNA 200-301

Authored by fery Susanto

Computers

University

Used 122+ times

AI Actions

Add similar questions

Adjust reading levels

Convert to real-world scenario

Translate activity

More...

Content View

Student View

100 questions

Show all answers

MULTIPLE SELECT QUESTION

1 min • 5 pts

1. What are two benefits of network automation? (Choose two)

A. reduced operational costs

B. reduced hardware footprint

C. faster changes with more reliable results

D. fewer network failures

E. increased network security

MULTIPLE CHOICE QUESTION

1 min • 5 pts

2. Which command enables a router to become a DHCP client?

A. ip address dhcp

B. ip helper-address

C. ip dhcp pool

D. ip dhcp client

MULTIPLE CHOICE QUESTION

1 min • 5 pts

3. Which design element is a best practice when deploying an 802.11b wireless infrastructure?

A. disabling TPC so that access points can negotiate signal levels with their attached wireless devices

▪ B. setting the maximum data rate to 54 Mbps on the Cisco Wireless LAN Controller

C. allocating nonoverlapping channels to access points that are in close physical proximity to one another

D. configuring access points to provide clients with a maximum of 5 Mbps

MULTIPLE SELECT QUESTION

1 min • 5 pts

4. When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two)

A. 2000::/3

B. 2002::5

C. FC00::/7

D. FF02::1

E. FF02::2

MULTIPLE CHOICE QUESTION

1 min • 5 pts

5. Which option about JSON is true?

A. uses predefined tags or angle brackets (<>) to delimit markup text

B. used to describe structured data that includes arrays

C. used for storing information

D. similar to HTML, it is more verbose than XML

MULTIPLE CHOICE QUESTION

1 min • 5 pts

6. Which IPv6 address type provides communication between subnets and cannot route on the Internet?

A. global unicast

B. unique local

C. link-local

D. multicast

MULTIPLE CHOICE QUESTION

1 min • 5 pts

7. Which command prevents passwords from being stored in the configuration as plaintext on a router or switch?

A. enable secret

B. service password-encryption

C. username Cisco password encrypt

D. enable password

Access all questions and much more by creating a free account

Create resources

Host any resource

Get auto-graded reports

Continue with Google

Continue with Email

Continue with Classlink

Continue with Clever

or continue with

Microsoft

Apple

Others

Already have an account?

Similar Resources on Wayground

98 questions

BASH_LATEX_GIT

Quiz

•

University

97 questions

SQL: GROUP Functions

Quiz

•

8th Grade - Professio...

100 questions

Python Quiz - Till Basic String

Quiz

•

University

100 questions

Computer Architecture Year 7 EOU Test

Quiz

•

6th Grade - University

100 questions

Ujian Tengah Semester Rekayasa Perangkat Lunak

Quiz

•

University

100 questions

WEB жобалау

Quiz

•

11th Grade - University

100 questions

ICT Input Output

Quiz

•

10th Grade - University

105 questions

Simulacro_Parcial1_EMBEB

Quiz

•

University

Popular Resources on Wayground

7 questions

History of Valentine's Day

Interactive video

•

4th Grade

15 questions

Fractions on a Number Line

Quiz

•

3rd Grade

20 questions

Equivalent Fractions

Quiz

•

3rd Grade

25 questions

Multiplication Facts

Quiz

•

5th Grade

$fractions$

22 questions

fractions

Quiz

•

3rd Grade

15 questions

Valentine's Day Trivia

Quiz

•

3rd Grade

20 questions

Main Idea and Details

Quiz

•

5th Grade

20 questions

Context Clues

Quiz

•

6th Grade

Discover more resources for Computers

18 questions

Valentines Day Trivia

Quiz

•

3rd Grade - University

12 questions

IREAD Week 4 - Review

Quiz

•

3rd Grade - University

23 questions

Subject Verb Agreement

Quiz

•

9th Grade - University

5 questions

What is Presidents' Day?

Interactive video

•

10th Grade - University

7 questions

Renewable and Nonrenewable Resources

Interactive video

•

4th Grade - University

20 questions

Mardi Gras History

Quiz

•

6th Grade - University

10 questions

The Roaring 20's Crash Course US History

Interactive video

•

11th Grade - University

17 questions

Review9_TEACHER

Quiz

•

University

Test CCNA 200-301

1. What are two benefits of network automation? (Choose two)

2. Which command enables a router to become a DHCP client?

3. Which design element is a best practice when deploying an 802.11b wireless infrastructure?

4. When configuring IPv6 on an interface, which two IPv6 multicast groups are joined? (Choose two)

5. Which option about JSON is true?

6. Which IPv6 address type provides communication between subnets and cannot route on the Internet?

7. Which command prevents passwords from being stored in the configuration as plaintext on a router or switch?

8. What are two southbound APIs? (Choose two )

9. Which set of action satisfy the requirement for multifactor authentication?

10. Which two capacities of Cisco DNA Center make it more extensible? (Choose two)

Access all questions and much more by creating a free account

Similar Resources on Wayground

Popular Resources on Wayground

Discover more resources for Computers