BMK Ultra Quiz - D3

(Single Choice) 1. How many GPIO boards does the BMK Ultra have?

• 2

• 3

• 4

• 5

(Multiple choice) 2. Which of the following parts uses HSSI when communicating with the control board?

• GPIO

• Current Sense

  PCB

• Local User Interface

• Slide Heater

(Single Choice) 3. What is the maximum priming time allowed for the Ultra CC1 reservoir?

• 18mins

• 10mins

• 5mins

• 2mins

(Multiple choice) 4. Select the correct descriptions.

• Air filter valve is closed by default

• Air tank dump valve is closed by default

• LP Enable valve is closed by default

• Waste Director valve is closed by default

(Single choice) 5. Select the correct description.

• All diaphragm pumps are the same

• Priming valves can be replaced individually

• 30 slide heaters are controlled by one PCB

• GPIO boards are interchangeable

(Multiple Choice) 6. Which of the following systems use high pressure?

• Vortex mixer

• Dispense Hammer

• Slide Drawer Air Cylinder

• Waste Capture Air Cylinder

• Volume Adjust

(Single Choice) 7. Which of the following statements about pressure is correct?

• The compressor must maintain a pressure of more than 100psi

• The Air Tank must maintain a pressure of at least 55psi

• The low pressure of 13psi is adjusted from the high pressure of 45psi

• The Air Tank must maintain a pressure of at least 75psi

(Single Choice) 8. Which of the following tests use a HALL sensor?

• Slide Heater in and out detection sensor

• Waste bottle liquid level detection sensor

• New version nozzle plate home sensor

• waste tub overflow sensor

• Waste bottle present detection sensor

(Multiple choice) 9. What is the function of Pressure Trap?

• Provide pressure to Bulk Bottle

• Provide pressure to Bulk Reservoir

• Control the on/off of related nozzle valves

• Detect overflow

(Single Choice) 10. If there is only one waste carboy, where should it be placed?

• left side

• Right side

• Both are ok

• It is not allowed