2018 IFGC CH 5A

·         01.Masonry chimneys shall be constructed in accordance with the ________________.

• 1.  a.International Fire Code (IFC)
• 2.  b.International Building Code (IBC)
• 3.  c.International Mechanical Code (IMC)
• 4.  d.International Residential Code (IRC)

·         02.Factory-built chimneys and vents for solid fuel appliances are regulated by the ____________.

• 1.  a.International Fire Code (IFC)
• 2.  b.International Building Code (IBC)
• 3.  c.International Mechanical Code (IMC)
• 4.  d.International Fuel Gas Code (IFGC)

·         03.An appliance shall not be connected to a flue serving a factory built fireplace unless the appliance is ________________ for such an installation.

• 1.  a.listed
• 2.  b.manufactured
• 3.  c.designed
• 4.  d.equipped

·         04.For a direct-vent fireplace with a sidewall vent, the vent termination must be a minimum of ______________ inches from the swing of a door.

• 1.  a.12
• 2.  b.18
• 3.  c.24
• 4.  d.6

·         05.Gas appliance connections to a masonry chimney flue must be at a point not less than ________________inches above the lowest portion of the interior of the chimney flue.

• 1.  a.6
• 2.  b.24
• 3.  c.18
• 4.  d.12

·         06.Appliance connections to a chimney or vent equipped with a power exhauster shall be made on the ______________ side of the exhauster.

• 1.  a.outlet
• 2.  b.inlet
• 3.  c.positive
• 4.  d.discharge

·         07.Masonry chimney flues shall be provided with a cleanout opening having a minimum height of ________________ inches.

• 1.  a.4
• 2.  b.6
• 3.  c.8
• 4.  d.10

·         08.A listed unvented room heater does not require a vent when the aggregate input rating of all unvented appliances in the room does not exceed ____________Btu/h per cubic foot of the room volume.

• 1.  a.20
• 2.  b.25
• 3.  c.30
• 4.  d.40

·         09.For vents passing through an attic, the attic insulation shield shall extend at least _____________ inches above the insulation material.

• 1.  a.6
• 2.  b.12
• 3.  c.2
• 4.  d.4

·         10.To protect vents in a concealed location from physical damage, steel shield plates shall have a minimum thickness of ____________________.

• 1.  a.No. 22 gage
• 2.  b.No. 16 gage
• 3.  c.No. 12 gage
• 4.  d.No 18 gage