RVTI Level 1 Chassis

The windshield wiper _____ operates the windshield wipers at all designated speeds.

• control

• button

• handle

• lever

When inspecting the parking brake, make sure there is no _____ creep.

• forward

• rear

• left-side

• right-side

A technician is testing a motorized RV. The first step enacted is ensuring that the seat moves up, down, forward, and back. Identify the next main steps for the technician to perform.

• disconnect the seat, test seat heaters, inspect armrest

• adjust seatback, test seat heaters, inspect armrest

• adjust seatback, test seat heaters, inspect head restraint

• disconnect the seat, test seat heaters, inspect head rest

The engine must run for a few minutes for this to work properly.

• heat and cool modes

• gear shifts

• braking system

• monitor and alarm

When performing PDI on chassis dash components, check rear and side view

• heaters

• monitors

• alarms

• mirrors

When performing PDI on chassis dash components, check

• side view alarm

• rear heater

• rearview monitor

• backup monitor

AS a typical part of PDI, a technician needs to ensure headlights function when

• dim and off

• bulbs are replaced

• bulbs are not new

• dim and bright

Which is a convenience light?

• fog light

• headlight

• brake light

• turn signal

What should be warm to be properly checked?

• hydraulic brake fluid

• wiper fluid

• power steering fluid

• coolant

When inspecting the hydraulic fluid level in the reservoir, clean the top of the reservoir before removing the cap to

• help avoid contamination of the top of the reservoir

• make it easier to read the information on top of the reservoir

• keep the cap in good condition

• prevent foreign material from entering the hydraulic system