Module 3-15

Another name for a machinist's hammer is _____.

• ball-peen hammer
• claw hammer
• veneer hammer
• sledgehammer

A heavy-duty tool used to drive posts or other large stakes is a _____.

• mallet
• sledgehammer
• bell-faced hammer
• ball-peen hammer

The proper angle for the edge of a cold chisel is _____.

• 90 degrees
• 60 degrees
• 45 degrees
• 30 degrees

The type of screw shown in the figure above is a(n) _____.

• Phillips head

• Torx®

• Allen®

• Robertson®

Which of the following screws comes to a relatively sharp point at the base of its drive socket?

• Reed and Prince
• Torx®
• Allen®
• Slotted

How many sides does a hexagonal shape have?

• Four
• Five
• Six
• Seven

In what way is a spud wrench different from a pipe wrench?

• It is not adjustable.
• It has smooth jaws.
• It is significantly shorter.
• Using a handle extension is recommended.

To quickly run a nut onto a bolt that resists spinning it on with the fingers, you can drive the socket with a(n) _____.

• striking wrench
• open-end wrench
• speed handle
• breaker bar

Another common name for lineman pliers is _____.

• locking pliers
• tongue-and-groove pliers
• needle-nose pliers
• side cutters

Because of its stiffness, a folding rule is better than a cloth or steel tape for measuring _____.

• vertical distance
• horizontal distance
• inside dimensions
• circular diameters