VEX V5 Clawbot

In the VEX robotic system, the claw motor is a...

• Input

• Output

• Storage

• Processor

Which block should be used to control the claw motor?

• A: spin ClawMotor3 open

• B: spin ClawMotor3 open for 90 degrees

This code should open and close a claw. What is wrong?

• The timeout should go at the end

• The timeout should be longer

• You need to open the claw first, not close

• You need to wait after the claw is closed

What does the timeout block do?

• It's like a wait block, but for claws

• It kills power to the motor if the motor isn't turning

• It stops the motor from spinning at the end of a turn

What should chance for this claw motor configuration? Select ALL that apply

• Change name Motor3 to Clawmotor

• Change forward to open

• Change reverse to close

• Change Gear Cartridge to 6:1

Where does the tiny pinion gear and axle go to connect the claw to the motor?

• A

• B

• C

• D

What component is between the angle structure and motor to HOLD the AXLE so it doesn't slip out of the motor?

• Spacer

• Pop rivet

• Collar with inset screw

• Screw

What is shown here, attaching the motor to the angle structure through the bearing?

• Pop rivets

• Screws

• Spacers

• Collars

Why are a right and left motor important for the robot navigating the maze?

• To have enough power to move the water bottle.

• To make the left and right turns.

• To have a backup if one motor fails

What is the high torque mechanism used here?

• Gear Train

• Chain Drive

• Leadscrew

• Worm and Wheel