When hitching a trailer to a tow vehicle, the hazard point created is called

• Shear

• Wrap

• Crush

• Pinch

This kind of potential hazard point is associated with a chain, belt, or gear drive

• Pinch

• Wrap

• Shear

• Crush

Which action is taken if the rollover protective structure (ROPS) is damaged

• Repair by welding

• Reuse after repairing

• Replace damaged ROPS

• Bend damaged section back to normal

Complete this action before returning a forklift to the field

• Clean the forklift

• Load test the forklift tines

• Make sure it is functioning properly

• Verify the forklift’s owning organization

To support a forklift for maintenance

• Use stacks of small blocks

• Use hollow-tube block units

• Blocks must be stacked until the forklift is level

• Be sure the blocks are solid one piece units

Before removing major assemblies on forklifts, always

• Consult with your supervisor

• Get recommended procedures from your trainer

• Consult and use recommended procedures from your trainer

• Consult and use recommended procedures from the technical order

This is the ideal position of the hyster 10k forklift mast prior to performing any maintenance

• Raised

• Locked

• Lowered

• Extended

Where is the eccentric located on the hyster 10k forklift that drives the fuel system lift pump

• Camshaft

• Crankshaft

• Rocker pump

• Fuel pump shaft

The hyster 10k forklift uses this type of electrical ground system

• 24 volt, negative

• 12 volt negative

• 24 volt positive

• 12 volt positive

On the hyster 10k forklift the positive battery cable connects to the starter solenoid through an emergency

• Solenoid

• Quick disconnect

• Disconnect switch

• Disconnect solenoid