MIdterm_fis

is a solderless device for temporary prototype with electronics and test circuit designs

(a)  

The set of connected holes can be called

• hole
• node
• pointers
• spot

lets you connect the breadboard to a power supply so that the other electronic components on the breadboard can be powered.

• bus strip
• bus connection
• bus strips
• bus spot

Bus strips are also sometimes called

(a)  

are made up of small holes, or perforations, where you can plug in your electronic components

• Bus strips
• Terminal strips
• power rails
• bus connection

The center groove on a breadboard allows certain types of integrated circuits called

• dual in-line packages
• triple in-line packages
• l in-line packages
• on-line packages

are arranged in lines that correspond to the rows and columns on the terminal strips, so that you can see and control which electronic components are connected.

• copper clip
• pcb
• silver clip
• metal clips

on a breadboard are very important, since they help you identify which holes on the terminal strip will allow you to connect your electronic components.

• labeled,
• markings

usually with a letter. Check the top of a terminal strip to see how the columns are

• labeled,
• markings

is a short piece of wire with hard metal points on the end which plug into the holes on a breadboard.

• Jumper wires
• thru hole
• led
• resistor