Module 3 Hand tools (Electrical 1)

Another name for a machinist's hammer is _____.

• Mallet
• Claw Hammer
• Ball-peen Hammer
• Sledge Hammer

A heavy-duty tool used to drive posts or other large stakes is a _____.

• Hammer
• Sledgehammer
• Screwdriver
• Wrench

The proper angle for the edge of a cold chisel is _____.

• 45 degrees
• 90 degrees
• 60 degrees
• 30 degrees

The type of screw shown in the figure above is a(n) _____.

• Robertson

• Flathead screw
• Hex head screw
• Torx screw

Which of the following screws comes to a relatively sharp point at the base of its drive socket?

• Reed and Prince

• Flathead screw
• Hex screw
• Torx screw

How many sides does a hexagonal shape have?

• 4
• 5
• 6
• 7

In what way is a spud wrench different from a pipe wrench?

• It has smooth jaws

• A spud wrench is larger than a pipe wrench
• A spud wrench and a pipe wrench are the same
• A spud wrench is used for gardening, while a pipe wrench is used for plumbing

To quickly run a nut onto a bolt that resists spinning it on with the fingers, you can drive the socket with a(n)

_____.

• striking wrench

• open-end wrench

• speed handle

• breaker bar

Another common name for lineman pliers is _____.

• Needle-nose pliers
• Slip joint pliers
• Diagonal pliers
• Side Cutters

Because of its stiffness, a folding rule is better than a cloth or steel tape for measuring _____.c

• liquid volumes
• soft materials
• vertical distances

• curved surfaces