Interpret Technical Drawing

What is EXTENSION LINES.

• 1. are lines that extend from the view to the dimension line to show the length and extent of the dimension

• 1. are used with figures and arrowheads to show the size of an object.

• 1. are thin, solid lines leading from - note or a dimension

• are broken or dashed lines which are used for edges and outlines which you cannot see when you look at the object.

What type of projection represented by the symbol below ?

• 1. 1^st angle projection

• 1. 2^nd angle projection

• 1. 3^rd angle projection

• 1. 4^th angle projection

.What is the type of section used for figure below?

• Broken out section

• Full section

• Half section

• Non of above

Section view is always refer to

• 1. The view that drawn in several section by section

• 1. The drawing that shown a cutaway portion of the object

• 1. External portion of the part which contain sectioning

• 1. The sector of isometric drawing which drawn in 3D

What is maximum dimension for 10.00 +/- 0.5

• 10.00 mm

• 10.50 mm

• 10.05 mm

• 9.5 mm

What is maximum tolerances for 10.00 +/- 0.5

• 10.5 mm

• 1.05 mm

• 1.0 mm

• 0.5 mm

When the print show dimensions  going from one location to the next.

Point to point positioning. this is a statement for ?

• Absolute dimension

• Incremental dimension

• Base line Dimension

• None above

Tags

CCSS.HSG.CO.C.9

What is the minor diameter for thread M10 X 1.5

• 11.5 mm

• 15 mm

• 10 mm

• 8.5 mm

Is a Multiview representation of a single part with dimensions and notes. This statement for?

• Detail Drawing

• Assembly Drawing

• Multi view Drawing

• Isometric view drawing

Center lines are used to locate or represent the centers of

• arcs

• circles

• hidden round features

• all of the above