Jointer 2

Never joint a board which has any________ in it, which has any__________ on it, and which has loose__________ in it.

• Metal, paint or varnish, glue and knot holes

• Holes, glue, and wood grain

• Coloring, knot holes, and saw dust

When jointing a board, you must stand________ the infeed table. Never stand at the end of the infeed table, as there is a risk with this tool that the board you are jointing could kick-back,

• Behind

• In front of

• Next to

When jointing the edge of a board, your board must be_________than the fence to joint it without a push stick. If the top edge of the board is lower than the fence, use a push stick.

• Smaller

• Taller

• Wider

Always fully complete each cut. Never______ in the middle of a cut or try to________your board back out of a cut. Damage to your board will result, as well as potential damage to you and your fingers.

• Stop, Flip

• Move, Stand

• Stop, Back

When jointing the face of a board, you will always use a_____________.

• Push block

• Scrap piece of wood

• Free hand