CO₂ Dragster Build Procedures

For CO₂ Dragster construction, what is the Drill Press used for?

• Extruding Axle Holes

• Cutting Large Holes for Dragster Body

• Shaping Dragster Body

• Intricate/Curved Cuts for Dragster Body

For CO₂ Dragster construction, what is the Bandsaw used for?

• Extruding Axle Holes

• Cutting Large Holes for Dragster Body

• Long Straight Cuts for Dragster Body

• Intricate/Curved Cuts for Dragster Body

For CO₂ Dragster construction, what is the Scroll Saw used for?

• Extruding Axle Holes

• Cutting Large Holes for Dragster Body

• Long Straight Cuts for Dragster Body

• Intricate/Curved Cuts for Dragster Body

For CO₂ Dragster construction, what is the Belt/Disc Sander used for?

• Shaping Dragster Body

• Cutting Large Holes for Dragster Body

• Long Straight Cuts for Dragster Body

• Intricate/Curved Cuts for Dragster Body

For CO₂ Dragster construction, what is the Milling Machine used for?

• Long Straight Cuts for Dragster Body

• Shelling and Cutting Large Holes in Dragster Body

• Smoothing the surface of Dragster Body

• Intricate/Curved Cuts for Dragster Body

What size drill bit should be used to extrude axle holes for Dragster Body?

• 3/16"

• 3' 16"

• 7/32"

• 7/32'

Which of these action(s) should be performed before using the drill press to extrude material?

• Lower the drill bit (while OFF) to ensure it doesn't contact the platform

• Make sure the drill bit is securely tightened with Chuck Key

• Make sure drill bit rotates straight.

• Clean off debris from drill bit

• Spray platform with water

After the axle hole is extruded, the operator should do this before removing the dragster blank.

• Power OFF drill and wait for drill to stop moving

• Make sure the drill bit is securely tightened with Chuck Key

• Remove C-Clamp and reach for dragster blank.

• Clean off debris from drill bit

Before using the Bandsaw, the operator should...

• Make sure guard is secured at the correct height.

• Make sure nobody is inside the Safety Zone

• Hold the dragster blank with free hand.

• Have a partner stand behind the machine to grab the blank.

When cutting dragster blank, it's better to...

• Leave some clearance, by cutting outside the marked lines.

• Cut exactly on the line as accurately as possible.

• Cut inside the marked lines.

• Turn dragster blank while cutting to make curved cuts.