Module 26107 Conduit and Pipe Bending Quiz

Which of the following should be used to cut EMT?

• Pipe cutter

• Hacksaw

• Table saw

• Chop saw

A die is used to _____.

• cut threads in conduit

• bend segments of conduit

• smooth the inside edge of conduit

• cut RMC and IMC

Which of the following eliminates wrinkling or flattening when bending PVC?

• Hickey

• Die

• Reamer

• Plug set

The radius of a circle is defined as _____.

• . the length from one edge of the circle to the other edge through the center point

• the distance around the circle

• the distance from the center point to the edge of the circle

• a closed curved line whose points are all the same distance from its center

Which of the following can be used to bend IMC?

• A reamer

• A hickey

• A die

• A hacksaw

A pocket knife can be used to deburr _____.

• EMT
• RMC

• PVC

• IMC

The formula π x D is used to calculate _____.

• circumference
• diameter

• radius

• surface area

Two junction boxes are each located on different walls, 12 inches from the same corner. Given a 90° bend with a take-up of 6 inches and a gain of 2-1/4 inches, what is the developed length of the conduit between them?

• 8-1/4 inches

• 10-3/4 inches

• 18-7/8 inches

• 21-3/4 inches

Two 90-degree bends in the same piece of conduit are required for a(n) ______.

• offset

• back-to-back bend

• kick

• parallel bend

When creating an offset using 10° bends (with a multiplier of 6) to cross a 6-inch obstruction, the distance between bends is ______.

• 36 inches
• 12 inches

• 24 inches

• 42 inches