TWR TYPE C PC SMT 1 2024

The following is not the phraseology for preparation for take off:

• Report when ready for departure.
• Are you ready for departure?
• Taxi to holding point [...] runway [...]
• Confirm ready for departure?
• Line up and wait.

What is the holding pattern aircraft arrival Rwy 04 from Namrole

• Tear Drop
• Direct
• Parallel
• Longitudinal
• Lateral

Additional operating hours after 17.00 WIT (08.00 UTC) can be done if there is a written request from the airline/operator to the General Ambon Manager no later than .... hours before operational hours end and carried out on the orders and approval of the General Manager or Appointed official. Meanwhile, Air Traffic Services are carried out earlier than operating hours can be done no later than ..... hours before operating hours at start (based on SOP)

• 1 hours and 13 hours
• 2 hours and 12 hours
• 2 hours and 24 hours
• 1 hours and 12 hours
• 1 hours and 24 hours

Procedures for damage to facilities are as follows: (except)

• Personnel report to the supervisor in charge the damage to the facility
• Personnel report to operations manager
• Personnel record in the ATS operational logbook
• The supervisor in charge or Air Traffic Controller continues the report to the unit in charge.
• A and d true

Aerodrome elevation is the elevation of the highest point of the landing area. The height of aerodrome elevation at pattimura ambon airport is...

• 33 ft
• 62 ft
• 60 ft
• 31 ft
• 45 ft

Determining the runway must be in accordance with wind speed and wind direction. Changes in runway can be caused by except

• Tail wind more than 10 Kts.
• There is turbulence/wind shear in the final area
• Bad weather conditions in the final area.
• Animal on the runway
• Other conditions that affect flight safety

The point at which an aircraft is granted an air traffic control clearance is …

• ATC Clearance
• ATC Instruction
• ATC Authority
• Restricted Area
• Clearance Limit

The length of runway plus stopway if available is ….

• TORA
• TODA
• RESA
• ASDA
• LDA

Where is area responsibility of Pattimura TWR in lateral and vertical limits?

• A circle with radius 30 nm centered at “AMN” VOR and SFC up to 2.500ft
• A circle with radius 5 NM centered on ARP and SFC up to 6000 ft
• A circle with radius 30 nm centered at “AMN” VOR and SFC up to 6000 ft
• A circle with radius 5 NM centered on ARP and SFC up to 2.500ft
• A circle with radius 5 NM centered on PMA and SFC up to 2.500ft

Pattimura Tower is included airspace classification of class:

• A
• B
• C
• D
• F