ITN - Module 17 - Build A Small Network

Which network design consideration would be more important to a large corporation than to a small business?

• Internet router

• Low port density switch

• Scalability

• Firewall

• Redundancy

What common protocols support applications and services used by users in a small network? (Choose all that apply)

• SMTP

• FTP

• HTTP

• DHCP

• DNS

Which software installed on key hosts can reveal the types of network traffic flowing through the network?

• MacOS

• Wireshark

• SSH

• Windows

• Linux

A technician has established a remote connection to router R1 to observe debug output. The technician enters the debug ip icmp command then pings a remote destination. However, no output is displayed. Which command would the technician have to enter to display log messages on a remote connection?

• monitor debug output

• monitor terminal

• terminal monitor

• terminal monitor debug

• access monitor

A technician is troubleshooting a network problem and has just established a theory of probable causes. What would be the next step in the troubleshooting process?

• Test the theory to determine cause

• Verify solution and implement preventive measures

• Identify the problem

• Document findings, actions and outcomes

• Establish a plan of action and implement th solution

You as an administrator are testing connectivity to a server. After the ping command was initiated the reply comes back as time expired. What indicator represent the reply?

• U

• !

• M

• .

• Q

A technician enters the tracert -6 command on a windows host PC. What is the purpose of the -6 command option?

• It only allows 6 hop counts

• It forces the trace to use IPv6

• Stops the tracert using IPv6

• It sends 6 probes within each TTL time period

• Forces only 6 replies at each hop

A network technician is investigating network connectivity from a PC to a remote host with the address 10.10.10.15. Which command, when issued on a Windows PC, will display the path to the remote host?

• traceroute 10.10.10.15

• trace 10.10.10.15

• tracert 10.10.10.15

• ping 10.10.10.15

When should an administrator establish a network baseline?

• At regular intervals over a period of time

• At the lowest point of traffic in the network

• When the traffic is at peak in the network

• When there is a sudden drop in traffic

Which statement is true about CDP on a Cisco device?​

• The show cdp neighbor detail command will reveal the IP address of a neighbor only it there is Layer 3 connectivity

• To disable CDP globally, the no cdp enable command in interface config mode must be used

• Because it runs at the data link layer, the CDP protocol can only be implemented in switches

• CDP can be disabled globally or on a specific interface