TLE 8 M2 Technical Drafting

What is an excellent means of improving the performance and condition of equipment and facilities?

• Improper use of tools

• Overuse of tools

• Maintenance

• Natural tear and wear

What is the responsibility of everyone in the workplace regarding hand tools, equipment, and paraphernalia?

• To avoid cleaning the tools

• To leave tools unattended

• To keep them well-preserved

• To misuse the tools

What is a common fault of drawing hand tools that occurs when tools are naturally worn as they reach their maximum use?

• Damage

• Improper use of tools

• Natural tear and wear

• Overuse of tools

What should be done before each use of tools according to the basic rules in maintaining hand tools?

• Ignore the manufacturer's specifications

• Keep all tools in bad working condition

• Examine/inspect the tools before each use and replace damaged tools

• Use the tools for any purpose

What should be avoided to prevent damage when using a pull-push rule?

• Improper use of tools

• Overuse of tools

• Damage

• Natural tear and wear

How should the T-square be stored when not in use?

• Placed on the floor

• Thrown in a toolbox

• Hanging by inserting the hole to a nail attached to a wall

• Lying flat on the table

What is associated with the use of quality hand tools in maintaining effective use of drafting tools?

• Improper use of tools

• Natural tear and wear

• Good workmanship

• Damage

What should be done to avoid malfunction of tools for effective performance?

• Do preventive maintenance

• Not check the tools regularly

• Be irresponsible

• Leave the tools unattended

What should be done before using a tool to keep the hands clean and free from dirt?

• Wear gloves

• Wash hands with soap

• Use a damp cloth

• Use hand sanitizer

How should the surface and edges of triangles and T-squares be treated before and after using them?

• Apply oil

• Clean with a wet tissue

• Wipe off with a damp cloth

• Spray with cleaning solution