6035 | Electrical Principles LO6

Which of the following is the correct bonding for connecting to all service pipe, along with exposed metals?

• Temporary continuity bonding

• Cross bonding

• Equipotential bonding

• Supplementary bonding

What tool is used when testing polarity?

• Approved voltage indicator

• Proving unit

• Multimeter

• Temporary continuity bonding

Which of the following is correct for maintaining the earth bonding where plastic components are present on a length of pipework?

• Temporary continuity bonding

• Cross bonding

• Equipotential bonding

• Supplementary bonding

Which of the following uses 6mm² cable and is correct for joining each individual pipe together?

• Temporary continuity bonding

• Cross bonding

• Equipotential bonding

• Supplementary bonding

On a domestic 3 pin plug, which coloured wire is connected to the 'Live' terminal?

• Yellow

• Green

• Blue

• Brown

Before an earth continuity clamp is placed, what must be done?

• Test polarity

• Clean any paint

• Test continuity

• Place temporary continuity bonding

Which of the following is correct for placing on the pipework before cutting into pipework?

• Temporary continuity bonding

• Cross bonding

• Equipotential bonding

• Supplementary bonding

Which is the test done when checking that each connection is made correctly?

• Continuity test

• Supplementary test

• Voltage indicator

• Polarity test

During a polarity test, the multimeter should read _____ between the Live and Neutral.

• 0v

• 110v

• 230v

• 240v

The type of electrical clamp shown here is:

• Pillar terminal

• Strip connector

• Claw type terminal

• Screw/Nut head terminal