Max Venturi System Operations

The video tutorial provides a comprehensive guide on setting up and operating the Max Venturi high flow system. It covers the necessary components, including the circuit, heater, and temperature probe, and explains how to assemble and connect them. The tutorial also details the different operating modes, troubleshooting tips, and calibration procedures. Finally, it offers guidance on adjusting flow and oxygen settings to ensure optimal performance.

What is included in the package of the Max Venturi high flow system?

• Only the heater

• The circuit, heater, tubing, and sometimes a cannula

• Only the cannula

• Just the tubing

What is the purpose of the temperature probe in the Max Venturi system?

• To measure humidity levels

• To measure the difference in temperature between the heater and the patient

• To adjust the oxygen concentration

• To control the flow rate

Which mode should be selected for non-invasive use of the heater?

• Standby mode

• Invasive mode

• Calibration mode

• Non-invasive mode

What temperature does the non-invasive mode of the heater reach?

• 25 degrees

• 31 degrees

• 40 degrees

• 37 degrees

What should be done if there is no temperature reading on the display?

• Ensure the temperature probe and water are properly connected

• Switch to invasive mode

• Check if the heater is turned off

• Increase the flow rate

What is the first step in calibrating the oxygen sensor?

• Turn off the system

• Adjust the flow rate

• Increase the oxygen concentration

• Remove the flow sensor

What should the calibration reading be close to for the oxygen sensor?

• 75%

• 21%

• 50%

• 10%

How can you adjust the flow rate on the Max Venturi system?

• By adjusting the flow meter

• By changing the temperature setting

• By switching modes

• By turning the system off

What is the correct way to read the flow meter?

• By looking at the top of the meter

• By checking the digital display

• From a good angle to ensure accuracy

• From any angle

How do you increase the oxygen concentration on the Max Venturi system?

• Switch to invasive mode

• Press the increase button

• Turn the knob counterclockwise

• Turn the knob clockwise