G8 Quiz

Which area that the holes will be connected horizontally?

• 1

• 2

Which area that the holes will be connected vertically?

• 1

• 2

What is the name of the area that marked with number 2?

• Power Rails

• Terminal Strips

What is the name of the area that marked with number 1?

• Power Rails

• Terminal Strips

Where we need to put resistor when we are using LED?

• Anode

• Cathode

Which is the output of the SERVO pin?

• Orange (1)

• Brown (2)

• Red (3)

Which are the correct statements for the image below?

• Wiper (middle pin), buzzer(+ pin) and LED (+ pin) need to add wires and connect to microbit pin 0/1/2

• The image is correctly connected. No need extra wire

• Resistor need to connect to positive hole

• Buzzer (+) pin need to connect to positive hole

Why we need to put resistor on LED negative's leg?

• Just to extend the flow of electrical current to another hole

• To reduce/to balance the flow of electrical current in a circuit

• To dim the LED

• To adjust the intensity of the LED

This code will be apllied to lit a LED.

What is the correct statement for the code?

• The value of P0 pins will be written as HIGH. It means that the LED will be ON

• The P0 pin will be OFF

• The code is for input only

• The code need to change to LOW to lit the LED

Where can we find this codeblocks?

• INPUT

• OUTPUT

• CONTROL

• MATH