Test #2

What cutting application is best done on the table saw with the use of a splitter and anti-kickback fingers?

• freehand cutting

• ripping

• cutting grooves

• cutting rabbets

When can the rip fence and miter gauge be used at the same time while cutting on the table saw?

• when bevel cutting

• when ripping

• when crosscutting

• when cutting a rabbet or dado

What is the maximum safe distance the table saw blade should be above the stock?

• 1/32" to 1/16"

• 1/4" to 3/8"

• 1/16" to 1/8"

• 1/2" to 3/4"

What blade type is used on the table saw to make rabbet or dado cuts?

• triple chip blade

• alternating top bevel blade

• combination blade

• dado set

When ripping with the table saw, how is the fence set up for the waste?

• to the right of the blade

• between the blade and the fence

• to the left of the blade

• does not matter, as long as you use a push stick

Which way is the nut turned on the arbor when removing a table saw blade?

• opposite to the direction of blade rotation

• the same direction as the blade rotation

• clockwise

• counterclockwise

What is the resulting cut if the mitre gauge is turned on an angle and the table saw blade is tilted?

• flat mitre

• end mitre

• compound mitre

• • bevel

The specs in the textbook state that when you're ripping on the table saw, you should always use a push stick if the stock between the blade and rip fence is less than?

• 6 inches

• 5 inches

• 7 inches

• 8 inches

A sliding compound mitre saw is not designed to make?

• Rip cuts

• Bevel cuts

• Cross cuts

• Mitre cuts

What is the general rule for using router bits?

• The smaller the bit the slower the router speed (rpm)

• The larger the bit the slower the router speed (rpm)

• Use HSS bits for difficult materials (particle board)

• Carbide bits are less brittle than HSS bits