4290-076. Workshop Processes and Methods

The pictured tools is used to:-

• Drill pilot holes

• Cut internal threads

• Remove broken studs

• Clean metric threads

Which one of the listed has the most ductile property?

• Stainless steel

• Copper

• Aluminium

• Cast iron

Mild steel can have a carbon content value of:

• Over 30%

• Up to 30%

• Over 3%

• Up to 0.3%

Which one of the following instruments can be used to measure the depth of a blind hole?

• Vernier gauge

• Feeler gauge

• Dti gauge

• Wire gauge

The pictured item of workshop equipment is used for:

• Wheel geometry

• Headlamp alignment

• Exhaust emissions

• Workshop heating

The pictured component will have a rating of:

• 20 amps

• 15 amps

• 12 amps

• 10 amps

The scuttle panel, inner wing and chassis leg can be identified by the numbers:

• A) 3,5 and 6

• B) 2,3 and 5

• C) 3,4 and 5

• D) 2,3 and 4

Which one of the following equations denotes Ohm's Law

• V=IxR

• V=I+R

• V=I-R

• V=I÷R

Health & Safety - Blue and White signs are said to be:

• Safe condition signs

• Mandatory signs

• Prohibition signs

• Caution signs

What do rotating magnets induce on windings which may surround them?

• Small electrical charge

• Chemical energy

• Mechanical energy

• non magnetic flux