Check 1 từ câu 26 đến 49

On a switch that is configured with multiple VLANs, which command will remove only VLAN 100 from the switch?

• Switch(config)# no vlan 100
• Switch(config-if)# no switchport trunk allowed vlan 100
• Switch(config-if)# no switchport access vlan 100
• Switch# delete flash:vlan.dat

Refer to the exhibit. A network administrator is reviewing port and VLAN assignments on switch S2 and notices that interfaces Gi0/1 and Gi0/2 are not included in the output. Why would the interfaces be missing from the output?

• They are configured as trunk interfaces.
• They are administratively shut down.
• There is no media connected to the interfaces.
• There is a native VLAN mismatch between the switches.

A network contains multiple VLANs spanning multiple switches. What happens when a device in VLAN 20 sends a broadcast Ethernet frame?

• Only devices in VLAN 20 see the frame.
• All devices in all VLANs see the frame.
• Devices in VLAN 20 and the management VLAN see the frame.
• Only devices that are connected to the local switch see the frame.

Refer to the exhibit. All workstations are configured correctly in VLAN 20. Workstations that are connected to switch SW1 are not able to send traffic to workstations on SW2. What could be done to remedy the problem?

• Allow VLAN 20 on the trunk link.
• Enable DTP on both ends of the trunk.
• Configure all workstations on SW1 to be part of the default VLAN.
• Configure all workstations on SW2 to be part of the native VLAN.

What happens to switch ports after the VLAN to which they are assigned is deleted?

• The ports stop communicating with the attached devices.
• The ports are assigned to VLAN1, the default VLAN.
• The ports are placed in trunk mode.
• The ports are disabled.

Match the IEEE 802.1Q standard VLAN tag field with the description. (Not all options are used.)

• no
• no

Refer to the exhibit. In what switch mode should port G0/1 be assigned if Cisco best practices are being used?

• trunk
• native
• access
• auto

Match the DTP mode with its function. (Not all options are used.)

• no
• no

Port Fa0/11 on a switch is assigned to VLAN 30. If the command no switchport access vlan 30 is entered on the Fa0/11 interface, what will happen?

• Port Fa0/11 will be returned to VLAN 1.
• An error message would be displayed.
• Port Fa0/11 will be shutdown.
• VLAN 30 will be deleted.

Which command displays the encapsulation type, the voice VLAN ID, and the access mode VLAN for the Fa0/1 interface?

• show interfaces Fa0/1 switchport
• show vlan brief
• show mac address-table interface Fa0/1
• show interfaces trunk