Tool Identification Quiz

What is the tool shown in the image used for?

• Set Square — this tool is used to mark a line at 90°.

• Tri-square — this tool is used to mark lines at 45° to an edge.

• Tri-square — this tool is used to mark a line at 90°.

• Set Square — this tool is used to mark lines at 90° and 45° from an edge.

What tool is used to mark lines at 90° and 45° from an edge?

• Mortise gauge — this tool is used to mark lines.

• Sliding bevel — this tool is used to mark lines at various angles.

• Combination square — this tool is used to mark lines at 90° and 45° from an edge.

• Combination square — this tool is used to mark long lengths of timber.

What tool is used to mark double lines parallel to an edge?

• Mortise gauge — this tool is used to mark double lines parallel to an edge.

• Marking gauge — this tool is used to mark a line parallel to an edge.

• Sliding bevel — this tool is used to mark lines at various angles.

• Try square — this tool is used to mark a line at 90°.

What is a steel rule used for?

• To draw straight lines at right angles to the edge.

• An accurate marking and measuring tool.

• To take sizes off drawings.

• To measure sizes.

What is a sliding bevel used for?

• To find 90° angles.

• To mark lines at 45°.

• To find 90° angles.

• To mark lines at various angles.

What is the tool used to insert and extract nails?

• Claw hammer

• Mallet

• Hammer

• Pin hammer

Which tool is used to make mortices in timber?

• Bevel edge chisel

• Mortice chisel

• Bevel edge chisel (for angles less than 90°)

• Firmer chisel

What is a smoothing plane used for?

• A general purpose plane for final finishing and cleaning up.

• Used for planing large sections of timber.

• Used to cut rebates.

• Used for planing large sections of timber.

What is a block plane used for?

• Used for planing large sections of timber.

• Used to plane end grain and form arises in timber.

• Used to dress doors for hanging.

• Used to cut rebates.

What is the purpose of a nail punch?

• This tool is for putting holes into the timber.

• This tool is used to drive nail heads below the surface of the timber.

• This tool is used for marking the surface of the timber.

• This tool is used to drive nail heads below the surface of the timber.