chap 3

What should be set first before starting a chain saw?

• The throttle

• The chain brake

• The choke

• The fuel mix

What should you check to ensure the chain saw is ready to start?

• The chain tension and oiler

• The blade sharpness

• The handle grip

• The spark plug

What should you do if the motor is cold?

• Start at low choke

• Start at full choke until it pops

• Start without choke

• Start at high speed idle

What is the purpose of the compression release on a chain saw?

• To increase speed

• To reduce starting effort

• To adjust the chain tension

• To lubricate the chain

What should you do after the motor starts at full choke?

• Turn off the saw

• Depress the throttle trigger once

• Increase the choke

• Pull the starter cord again

Where should you place your foot in the ground starting technique?

• On the chain

• Through the rear handle

• On the throttle

• On the blade

What is the kickback corner?

• The lower quadrant of the bar tip.

• The upper quadrant of the bar tip.

• The middle section of the bar.

• The entire length of the bar.

What should you always do while the saw is running?

• Keep one hand on the saw.

• Keep both hands on the saw.

• Keep the saw on the ground.

• Keep the saw in a case.

What is the recommended position for cutting with a chainsaw?

• Above shoulder height

• Below shoulder height

• At shoulder height

• On the ground

What should you do with logs to prevent them from rolling?

• Paint them

• Block them with other pieces of wood

• Cut them into smaller pieces

• Tie them with rope