CDS Air Bag Systems Glossary and Component Guide

CDS Air Bag Systems Glossary and Component Guide

9th Grade

10 Qs

quiz-placeholder

Similar activities

floor jacks and jack stands

floor jacks and jack stands

9th - 12th Grade

15 Qs

Vehicle Maintenance

Vehicle Maintenance

9th Grade

10 Qs

Tires

Tires

9th - 12th Grade

12 Qs

Rancho - Disc Brake tools - Identify Use

Rancho - Disc Brake tools - Identify Use

9th - 12th Grade

10 Qs

Medical Abbreviations Quiz

Medical Abbreviations Quiz

9th Grade

11 Qs

automobiles

automobiles

5th Grade - University

10 Qs

Electrical Knowledge Test

Electrical Knowledge Test

9th - 12th Grade

15 Qs

Nissan

Nissan

1st - 12th Grade

14 Qs

CDS Air Bag Systems Glossary and Component Guide

CDS Air Bag Systems Glossary and Component Guide

Assessment

Quiz

Specialty

9th Grade

Hard

Created by

Bryan Peck

Used 1+ times

FREE Resource

10 questions

Show all answers

1.

FILL IN THE BLANK QUESTION

30 sec • 1 pt

The passenger air bag indicator light shows whether the passenger side deployment loop is "on" or "______".

2.

FILL IN THE BLANK QUESTION

30 sec • 1 pt

Squibs are used in emergency mechanisms where gas pressure needs to be generated quickly in confined spaces, while not harming any surrounding persons or ________.

3.

FILL IN THE BLANK QUESTION

30 sec • 1 pt

An Air Bag is an inflatable type of deployment device located anywhere in the vehicle from the steering wheel, passenger dash pad, door panels, seats, knee bolsters, roof rails, and even A, B, C, pillars. These can also be referred to as '______'.

4.

FILL IN THE BLANK QUESTION

30 sec • 1 pt

A Side Curtain (Head curtain) is a type of inflatable airbag usually located along the vehicle roof line interior at the edges of the headliner and or windshield. Curtain type airbags can also be located in the upper portions of the vehicle's ______.

5.

FILL IN THE BLANK QUESTION

30 sec • 1 pt

A Pre-tensioner (buckle) is another type of deployment device (SQUIB) and is built into the buckle side of the lap portion of seat belt. It can be challenging to determine if these have been ______.

6.

FILL IN THE BLANK QUESTION

30 sec • 1 pt

Most manufacturers require a calibration of the system whenever the vehicle has been involved in a _______.

7.

FILL IN THE BLANK QUESTION

30 sec • 1 pt

Manufacture instructions should be referred to when determining whether or not to replace the _______.

Create a free account and access millions of resources

Create resources
Host any resource
Get auto-graded reports
or continue with
Microsoft
Apple
Others
By signing up, you agree to our Terms of Service & Privacy Policy
Already have an account?