Maple Tool ID Quizizz #2

What is the primary function of a Dead End Tee?

• To allow sap to flow in both directions

• To connect three tubing lines together

• To cap off the end of a tubing system while maintaining a connection

• To seal a spout hole in a tree

What is the purpose of an End Hook 5/16”?

• To close off unused tubing lines

• To secure tubing at the end of a line

• To hold a spout in place

• To clean out sap lines

Identify the part in the image. What is this tool?

• End Hook

• Slide Fitting 5/16”

• Tee with Plug

• Wire Tie

What is the function of an End Ring?

• To tighten and secure mainline tubing

• To cap off the end of a mainline

• To connect tubing to a spout

• To allow air into the tubing system

What tool is shown in the image?

• Quick Disconnect 5/16”

• 5/16” End Y Fitting

• Tee with Plug

• Dead End Tee

What is the purpose of Tubing Support?

• To hold and stabilize tubing in place

• To increase sap flow

• To prevent leaks in spouts

• To block off unused tubing

A Plug in a maple syrup system is mainly used for:

• Blocking unused ports or tubing ends

• Increasing the sap collection rate

• Holding tubing in place

• Connecting multiple tubing lines

What does a Spout Plug do?

• Seals an unused spout hole in a tree

• Filters impurities from the sap

• Helps regulate sap flow

• Connects a spout to a bucket

What is the primary function of a 3/16” Spout?

• To be used in high vacuum systems

• To drill holes for sap collection

• To act as a mainline connector

• To fit into a 3/16” tubing system for sap collection

What is the purpose of a Tee with Plug 3/16”?

• To allow for easy sap flow adjustments by plugging one side of the tee

• To connect the mainline to the spout

• To drill into the tree for sap collection

• To clean out tubing after the season