Maple Tool ID Quiz #3

What is the primary function of an End Hook 3/16”?

• To attach tubing securely at the end of a line

• To connect multiple spouts together

• To increase the sap collection rate

• To filter sap before it enters the mainline

What is the purpose of the Two-Hand Tubing Tool?

• To seal tubing ends

• To create tight connections between tubing and fittings

• To drill tap holes in trees

• To measure sap flow

Identify the part in the image. What is this tool?

• Wire Tensioning Handle

• One-Hand Tubing Tool

• Quick Disconnect 5/16”

• Slide Fitting

What does a Quick Seal Mainline Entrance Fitting do?

• Allows a secure and leak-free connection between mainline and tubing

• Seals off unused mainline holes

• Filters debris from the sap

• Regulates vacuum pressure in the tubing

What is the function of a Mainline Base Tee?

• To split mainline tubing into two branches

• To connect a smaller tubing line into the mainline system

• To cap off the mainline at the end

• To control the sap flow rate

Identify the tool in the image. What is this tool?

• Tubing Cutter

• Wire Tie

• Mainline Stars

• Spout Plug

What is the purpose of a Mainline Tee?

• To allow mainline tubing to branch into another section

• To plug an unused mainline end

• To secure the tubing with a wire tie

• To filter sap before entering the mainline

What is a Y Fitting used for?

• To split tubing flow into two paths

• To attach spouts to buckets

• To drill holes in trees

• To tighten tubing connections

What is the purpose of an End Cap in a maple tubing system?

• To seal the end of a mainline or tubing system

• To regulate sap flow

• To connect different tubing sizes

• To serve as a filter before sap enters the mainline

What is the function of a Tubing Cutter?

• To remove damaged sections of tubing

• To seal tubing ends

• To stretch tubing for better connections

• To attach spouts to trees