Air/Brad Nailer Safety Quiz

Before using an air/brad nailer, what is the first thing you should do?

• Plug it into the power source

• Check that it is clean and free of obstructions

• Load the nails

• Test it on a piece of wood

What safety gear should you wear when using an air/brad nailer?

• Sunglasses

• Safety goggles

• A hard hat and knee pads

• Earplugs and flip-flops

Which of the following is important when loading nails into an air/brad nailer?

• Only load nails that are the right size for the tool

• Overload the magazine to save time

• Use nails from any brand, regardless of size

• Tap the nails in with a hammer

What should you do if a jam occurs in the nailer?

• Turn the tool upside down and shake it

• Use your hands to force the jam out

• Disconnect the air supply, then clear the jam carefully

• Keep using the tool to try to clear the jam

How should you position your hand when holding the air/brad nailer?

• Keep your hand away from the nozzle and trigger

• Place your hand over the nozzle to control the airflow

• Hold the tool with both hands, one near the trigger

• Always place your hand directly under the tool

When is it safe to remove your finger from the trigger of the air/brad nailer?

• Only when the tool is not loaded with nails

• After firing a nail

• When you are setting up to use the tool

• Never remove your finger from the trigger

How should you store the air/brad nailer when not in use?

• Leave it on the floor or table

• Place it with the trigger facing up on a flat surface

• Hang it up with the air hose attached

• Store it in a safe, dry place away from children

What is the correct way to fire the air/brad nailer?

• Press the nose into the surface you are nailing, then pull the trigger

• Hold the tool against your body, then pull the trigger

• Aim the tool at the ground and fire

• Fire the tool from a distance

What should you do if you need to make adjustments to the air/brad nailer?

• Adjust the settings while the tool is still plugged in and pressurized

• Always make adjustments when the tool is off and air supply is disconnected

• Adjust the tool while it's firing to see results

• Hand the tool to an adult for adjustments

What is the proper way to dispose of used nails or other debris from the tool?

• Leave the debris in the tool for future use

• Sweep up the debris and discard it in the trash

• Throw the debris in the air to clean the area

• Keep the debris in the tool until it's full