Soundness Test on Sanitary Pipework Quiz 4.2

Which of the following is NOT a piece of equipment required for a soundness test on sanitary pipework?

• Drain plugs

• A water gauge

• A hand pump

• A pressure valve

What is the purpose of using a hand pump in a soundness test on sanitary pipework?

• To measure water flow

• To pump air into the system

• To seal the pipework

• To drain water from the system

What is the purpose of sealing the pipework with drain test plugs at stage 1?

• To prevent air from entering the pipe

• To ensure a water seal

• To allow water to flow freely

• To increase water pressure

Where is the top plug sealed in the pipework?

• At the base of the soil stack

• At the top of the vent pipe

• In the middle of the pipe

• At the bottom of the vent pipe

How can the bottom plug be inserted and sealed?

• Through the top of the vent pipe

• Through the access cover at the base of the soil stack

• By removing the top plug

• By using a special tool

What method is suggested for sealing the top plug with water?

• Using a hose

• Pouring water from a jug

• Using a water pump

• Spraying water with a spray bottle

What is the purpose of running the taps of each appliance for a few seconds in the system?

• To clean the taps

• To ensure the system is air tight

• To test the water pressure

• To check for leaks

What is the purpose of the tee junction in the setup described?

• To connect the water gauge to the drain plug

• To measure the water pressure

• To attach the hand pump to the system

• To seal the rubber tube

What unit of measurement is used by the water gauge mentioned in the text?

• mm/watergauge

• psi

• liters

• meters

What is the maximum reading that should be present on the water gauge when using the hand pump?

• 38mm

• 50mm

• 45mm

• 60mm